Worm mesh and PEC


Joe Zeglinski
 

Pawel,
 
    Don’t forget to SAVE the current PEC curve data first. before doing a fresh one.
You never know if your initial one, which can be restored,  was better to begin with. Would be nice if PemPro popped up a reminder to do so, or it would just save it automatically, as a backup, even for comparison tests.
 
Joe Z.
 


Pawel Lancucki
 

Hi Guys

Thank you for feedback. I think I will re-run PEC anyway after the worm mesh adjustment, now on the next full moon ;-)

CS

Pawel Lancucki



Roland Christen
 

Theoretically the PE should remain the same. However, it may not if there is a peculiar wear pattern on the worm that is different at various tooth heights.

Rolando



-----Original Message-----
From: 'Pawel T. Lancucki' pawel.lancucki@... [ap-gto]
To: ap-gto
Sent: Fri, Mar 29, 2019 7:50 am
Subject: [ap-gto] Worm mesh and PEC



Hi guys

I have a quick question. It is tome for periodic worm mesh adjustment on my AP1100 (not the new version with spring loaded worms). The adjustment process itself is easy enough, but I have a question: after RA worm mesh, will the PE curve remain valid, or should I re-train PEC?

CS

Pawel Lancucki




Joe Zeglinski
 

Hi Pawel,
 
    The PEC doesn’t need to be redone, as long as you didn’t move the locked RA axle relative to the worm. The worm gear and its worm are still in the same position, and any relative position “mating discrepancies” in their teeth  have not changed. You only need to reprogram the PEC pattern if they have been shifted, such as possibly during a regreasing.
 
Joe


Geert
 

Why would a periodic adjustment be needed, do you see backlash?  If not, don't bother.

 

Geert Vdbulcke

 

Van: ap-gto@...
Verzonden: vrijdag 29 maart 2019 12:48
Aan: ap-gto@...
Onderwerp: [ap-gto] Worm mesh and PEC

 

 

Hi guys

I have a quick question. It is tome for periodic worm mesh adjustment on my AP1100 (not the new version with spring loaded worms). The adjustment process itself is easy enough, but I have a question: after RA worm mesh, will the PE curve remain valid, or should I re-train PEC?

CS

Pawel Lancucki


Pawel Lancucki
 

Hi guys

I have a quick question. It is tome for periodic worm mesh adjustment on my AP1100 (not the new version with spring loaded worms). The adjustment process itself is easy enough, but I have a question: after RA worm mesh, will the PE curve remain valid, or should I re-train PEC?

CS

Pawel Lancucki