Thanks Clayton. Frank

#APCC

I recently acquired one and was able to connect it to APPC to get environmental data. I couldn’t get GPS input, but haven’t had time to investigate. Frank

#APCC

Hi Brian, Here is my setup and an image of the Eastern Veil Nebula taken with the AG Optical 14.5” CDK on the AP 1600. Frank

Nice image. Russ Croman’s NoiseXterminator is a reasonably priced plug in for PI that works in both linear and non-linear modes. His StarXterminator is also very useful. Once I have an RGB image I use

One useful tool in combating light pollution is the concept of light trespass. The county I live in has a requirement that all lights be shielded to prevent intrusion beyond the property line. Why sho

I live on the coast half way between LA and the Bay area. The sky is fairly dark particularly out toward the ocean. We are blessed with a perpetual water shortage that has stopped all new development.

From the MDL manual: Many cameras produce images that are offset slightly from the nominal starting position. This results in a misalignment of the Bayer pattern, which in turn produces grossly incorr

I have had occasions where the APCC error message page appears minimized below the task bar. I just right click it in the minimized state to close it. I then select View Error Messages in APCC and the

What price applies if you were already on the list? Frank

I was attracted to putting the NUC on the OTA, but have found no practical advantage. I have two StarTech USB 3.0 7-port hubs on the mount and can download images simultaneously from two 16803 cameras

I have a side by side configuration mounted on an AP 1600 and the two main scopes each have a piggyback scope. All scopes have cameras and electronic focusers and there are two filter wheels. I have t

One computer can handle all of the equipment for two scopes with no problem. Other than camera downloads, most of the interfaces are low data rate. I considered mounting a computer on the declination

Here is my AP1600 quad scope rig. One 250 mm RC scope One 152 mm refractor Two 80 mm guide scopes. Two through the mount power lines each feeding a ten-port Rigrunner power distribution unit. One thro

I have an industrial mini computer near the mount that has RS 232 ports that I use to connect to the mount. Frank

Check out RelayPros. They have am easily configurable software control tool. https://relaypros.com/Relay/Relay/USB_Relay_Controller For a more packaged solution check out Kmtronic. They have a nice co

I’m not impressed with the image, particularly with an 80 mm scope. AP cautions against large moments of inertia. You are moving the center of gravity a long way from the RA axis. Even with good balan

AP has an extension for the counterweight shaft. Frank

You would probably have to replace the motors. Frank

A go to is not the same as an alt/az pointing that you would use to line up a polar scope in the center of the RA axis on a mount. In a go to the Declination of Polaris is 89 degrees 20 minutes, so th

AP has a procedure for adjusting the mesh between the worm and the worm gear that will eliminate the play in either axis. The play is easier to detect in RA because of the large moment arm provided by