Hi Geoff, Electrical tape will do the job. Regards, Yves

Electrical tape will do the job. Regards, Yved

Forget about it. Just noticed that I inversed the plug and socket in my mind. 😏

You won't be able to plug it at all because the center pin is bigger in that case. Regards, Yves

Hi Todd and all !!! Where did you get version VCP4-P02-10 ? Thanks ! Happy New Year !!! Regards, Yves

ACP uses the ASCOM Driver. You need to select the park position from the Driver not from APCC . Yves

Hi Don, Began with the same setup as suggested by Christopher in 2003. Since ten years, I'm using exactly the same setup as you expect to use and it's working great. Icron are very good products. Rega

Hi Ray, Now it's working !!! :-) Regards, Yves Le 15/01/21 11:17, Ray Gralak <groups3@...> a écrit : For those of you with APCC Pro and "Check for updates" is not working, please try this versi

Hi Ray, Thanks for your explanation even if I always understood the naming protocol. That said... I never being diagnosed but I suffer a kind of dyslexia...unfortunately it seems even worse with age a

#APCC #ASCOM_V2_Driver

Sorry Ray, a typo error...I meant RC2 !!! Yves

#APCC #ASCOM_V2_Driver

Ray, Here is the proof without a doubt why I was confused about the ASCOM Release Candidate version. On the attached ASCOM diagnostics window it's written 6.5RC2 - 6.5.0.3035. Maybe it should be writt

#APCC #ASCOM_V2_Driver

Hi Ray, Yes, there was an ASCOM 6.5RC2. Just checked the GitHub web site but no executable file found anymore even if it's written 6.5RC2. I already got this file on my USB key and initiated an instal

#APCC #ASCOM_V2_Driver

Hi Ray, Just did a few mapping points with ASCOM 6.5 SP1 - 6.5.1.3136 (link you provided) and everything is going well. It's seems that the problem appeared with SP2. Regards, Yves

#APCC #ASCOM_V2_Driver

Hi Ray, Did a point run last night and got bad results with ASCOM 6.5 SP2. Downgraded to version ASCOM 6.4RC1 and everything went fine. You mentioned ASCOM 6.5 SP1 beta version but I'm a bit confused.

#APCC #ASCOM_V2_Driver

Ray, I can assure you that my computer clock was well synchronized. It's part of my ritual before any imaging session since a long time. If you read carefully my latest message, I unparked the mount f

Sorry Rolando and Ray but Park1 position was running well until the latest APCC version. My computer clock is always synchronized. Would you explain me why my mount was badly parked to Park5, unparked

Hi Ray, This morning, the mount behaved the same as other night. APCC was the only software connected, no ASCOM driver. I parked the mount to Park1 position and the mount slewed at the opposite direct

Not sure I really understand your statement. I parked the mount manually via APCC. Yves

Ray, The meridian delay set to "0" appeared at 03h16 The park message appeared at 03h28 There is a 12 minutes difference between both. Regards, Yves

Hi Ray, This morning at the end of my imaging session I parked the mount at Park1 position as usual but the mount was slewing at the opposite direction (Park4 or Park5). I stopped the slew and re-init