Since I am selling my Mach1 with its GTOCP4, is there a way to do a factory reset? Thanks,

We know what the problem is and our software engineer is preparing a solution. Please hang in there. Rolando

I have been suspecting that there is a subtle bug in the CP4 code for logical horizon limits for some time now. Sometimes my Mach1 with CP4 will not go East/West beyond some point near the meridian

I had a similar incident with my AP1200 w/CP4 and switched back to the CP3. Howard found that the coordinates in the CP4 were preventing the mount from moving east. I could use the N/S/W buttons to

Actually, Rolando, you needn't answer the questions about dithering. I'm not happy with the performance of my Mach1GTO right now (delivered in Mar 2010). The optimal amount of dithering is probably

With my old FSQ-106, I use an L filter (cutting UV and IR). Star images in L or B are very fine. Christian

Hello, Since March 2020 I’m using a GTOCP4 on my AP1200 without issues. Last night however, after some hours of imaging, when I issued a GoTo from TheSky to another object, the mount did not

Thanks a lot ! Christian

The implicit question is: how much dithering is too much? How much is not enough?

All: I can now confirm that this new process of leveling Park 1 / Park 4 to be parallel to each other works well and much better for me in this low latitude than trying to level the OTA with the DEC

It appears to have worked fine here at home. We won’t know for sure until I get “out there “ and it gets dark and cold. Will take the old laptop as a backup. I did go through the setup of the

There are a boatload of variables, so I cannot even conceive an answer to that. Rolando

Sorry. I replied to an ancient thread ("New files uploaded"), and my reply is four pages down. Sorry. OK, this comment from Rolando from 05/06/2019 caught my eye: "with MaximDL it takes only one or

This is an old thread, but this comment from Rolando on 05/06/2019 caught my eye: "with MaximDL it takes only one or two guide moves to come back to the zero line. With the 28% Dec in PHD2 it takes 5

Ditto Sent from my T-Mobile 4G LTE Device

The astronauts arrived safely home yesterday. https://www.bbc.com/news/science-environment-53621102 Congratulations on a job very well done to the entire team at NASA and SpaceX! Karen

Hello Howard The other end of the Ethernet cable is plugged directly into the PC. If you think this is worth, we can test with a network router. Christian Le 03/08/2020 à

I will forward this to our customer service guys. Rolando

Hi Christian, You need to enter an IP address. The driver does not perform discovery of the mount's IP address, so its default IP address is set to "0.0.0.0". -Ray Gralak Author of APCC

The first link will provide the ip address calculated from your Ethernet hostname. Try opening a browser with: 169.254.0.192