Stacey, <G> You’re most welcome. Enjoy! Regards, George George Whitney Astro-Physics, Inc. Phone: 815-282-1513 Email: george@...

Doh!! That was embarrassing! Thanks.

Tony A well done video. Thanks! Bryan

Stacey, Reference page 3 of the instructions. Regards, George George Whitney Astro-Physics, Inc. Phone: 815-282-1513 Email: george@...

Stacey, It is measured from the end of the threads. Adapters will thread on until they butt up against the end. Regards, George George Whitney Astro-Physics, Inc. Phone:

I got my Stowaway yesterday. BEAUTIFUL! Thanks to Roland, Marj, and Karen! Stay safe. I note that the 92FF flattener shows a required nominal backfocus of 64.1mm. Since the camera end of the

The Pelican and similar cases may work but they are expensive. I have always used large tool boxes which are available from Home Depot, Lowes, and similar. I have one for my 1100 and another for my

Once again: If you have a permanent setup where the mount and scope are never moved, then Unpark From Present Position. If you are mobile and tear down your setup at the end of each session and set

It doesn't work that way, Joe. These auto-timezone settings use any location data that your computer can derive from its public IP address or any observed wifi networks, if visible (databases of wifi

Hi Rolando, What is the difference between unparking from last park and unparking from a specified park position when I startup? FYI, I always start from park3. My setup is mobile, but I don't

I recommend to always do this for mounts that are never moved and have permanent scope setups. Rolando

Thanks Joe, I have never touched it but worth trying... - Mikko

Unparking now from the last position as instructed earlier. Mach finds it's home now nicely. - Mikko

Mikko. Why are you avoiding the button for Windows to set Time Zone automatically? It can sometimes be set to a convenient USA west coast one, by some USA software installers, perhaps even

Are you unparking from previous position? Or are you forcing the mount to unpark from one of the 4 park positions? Rolando

Thanks Steve, all ideas are appreciated. Sequence Generator Pro does everything for me so Mach1 is connected through the ASCOM. I used Platesolve2 previously for plate solving but recently changed to

I understand but which programs are connected to the mount? For example I use ACP to image with and have APCC Pro so I have the ACP configured to connect to the ASCOM Driver, APCC to connect via the

Steve no hand controller. Never changed anything from what I have done from the day 1. Just suddenly having plate solve problems and trying to understand what's causing them. - Mikko

Where else could there be time settings which would confuse the Mount or the program? This one is spot on... - Mikko

I can’t offer much as I haven’t followed this carefully but how many programs are connected to the mount? Have you initialized with only the hand controller? -Steve