I will find out for you. Marj Astro-Physics Phone: 815-282-1513 Fax: 815-282-9847 http://www.astro-physics.com

Thank you Tim for your help with the setting of the "safety zone". I will try the procedure on the next clear night (here in Italy we're having a very cloudy, cold and snowy winter). All the

Marjorie Christen wrote: Hello Marj, Can you please tell us if the AP driver will be also released for the Macintosh version of TheSky? Thanks! Diego Meozzi

To all, We are finishing up the preparations for the new chip release. Please be patient just a while longer and we will release all details. Please don't ask specific questions now, that will only

To all, Software Bisque has completed the Astro-Physics driver for TheSky and will include it in conjunction in their version 5.00.012 update due to be released in a few weeks. You will be able to

To set the safety zone, first your time and location should be correct, including daylight savings time setting, since they determine where the meridian is located. The second step is to do your

Diego. Did you ever get an answer? I'm also interested in the right method since the manual is 'nebulous' <g>. Mike Garrett Diego Meozzi wrote:

Thanks Andy Forsberg wrote: -- Best regards, Chuck Hancock DMD McDonough GA USA

OK! chris1011@... wrote: -- Best regards, Chuck Hancock DMD McDonough GA USA

Chuck, I use the leveling routine starting on page 20 in the GTO KEYPAD CONTROLLER manual. After setting the scope up for my latitude (use polar alignment daytime procedures then starting from park,

In a message dated 2/1/01 8:36:43 PM Central Standard Time, cdh59@... writes: << After doing a two star calibration and exiting the calibration routine, I went up to the Objects menu,

After sending the first one to egroups, I figured yahoogroups was a more current address. I guess I haven't been paying attention. -- Best regards, Chuck Hancock DMD McDonough GA USA

I have a question about a lockup that occurred this past Saturday. Aftere setting up and calibrating, I like to point the scope at celestial North to see the view through my finder scope. Just a

I have a question about a lockup that occurred this past Saturday. Aftere setting up and calibrating, I like to point the scope at celestial North to see the view through my finder scope. Just a

Does anybody know how to set the "safety zone limits" with an AP GTO mount? The manual is quite obscure: it simply says: a) Determine by trial and error how close in degrees you can safely slew your

TEST

Last week I reported that The Sky for Macintosh would not control my 1200 GTO mount. Well, after a lot of tinkering with no joy I re- installed The Sky from version 5.0.0 and it now works! Alex

I forgot to mention that I have a small application for testing the scope connection with a Macintosh. It lets you type in commands and send them to the scope; then displays what the scope sends back.

Hi Robin, Thanks, I'll have a look at Starry Night Alex Colburn

If it is a cannot link to Yes, I've checked the cable its just fine. command sDD*MM Meade page of everything Apparently, It wasn't realized we had either When the LX200 first appeared on the market