Steve, If the cable won’t come to the box, take the box to the cable! You have to free the CP3 from the mount and then reverse the cables…yes, the box will dangle in the air. Regards,

First, I am huge fan of AP, APCC, and APPM. The 1100 mount is terrific (the modular components are genius and polar alignment adjustments are quick and easy), and the software is stable and

Hmm interesting. I always get an error when I try to use ASCOM. I'll try it again later after a clean boot and see what happens.

Bill, > The Kepler driver package installs a driver for non Kepler cameras as well. Thanks, I didn't know that! They should make that clearer on the website. I just downloaded it and took

Thanks.I will give it another shot in a couple of weeks.

The Kepler driver package installs a driver for non Kepler cameras as well.

Hi Bill, Were you using a Kepler camera? There is no official FLI ASCOM Camera driver except for Kepler cameras: https://www.flicamera.com/software/index.html It matters because many of the ASCOM

Not sure if it was the idea to move to neutral balance, or the seeing here is better. The guided performance is much better in this configuration.

Well then.... 20 mins here:

Yes it was. Not sure why that matters. I think there is a legit problem with APPM working with ASCOM Camera. In fact, I tried 3 other cameras and it doesnt work at all. Cant get an image from the

I was going to suggest “reboot the router”… I’ve suspected bad arp tables on my pfsense box (not with the Mach2 tho where I only use USB; I’ve found WiFi too fiddly and SkySafari lacking

I'm not sure what you are trying to say, but all ASCOM drivers are supposed to work the same. Was the FLI ASCOM driver you used officially developed by FLI? There is no special code in an ASCOM

Okay but I tested it with an FLI camera and its ASCOM driver. 🙁

Yes, I believe that. The point was that it's the ASI ASCOM Driver that's the issue, not APPM. APPM acts the same way for all ASCOM cameras. -Ray

For the first, check those boxes that say to exclude points past a certain error amount. I set those to 10 but 20 is usually fine. The key thing is that you have outliers if you look at the plot and

@Bill Long wrote: Post your model tab data. Curious to see your results. Sure. This is with an NP101is still s, short and light and shouldn’t have much flex, but this was only 37 points,

Had to take a break but should be back in the swing tonight with this combo. I took Rolands advice and neutral balanced both axis on the Mach 2. Here is a photo of the beast in route to a fun

Post your model tab data. Curious to see your results.

ASCOM Camera just throws the same errors he mentioned when used directly. The SIM might work but a real camera doesn't seem to.

Ray said: It's too bad you couldn't get around to proving APPM's ASCOM interface also works with the ASCOM Camera Simulator, as I know it does. Here's a screenshot as proof: J I will. I