This is what I just ordered; as set of 3 each (male/female) XT60 pigtails. Amazon.com: Upgrades XT60 Connectors 12awg 5.9inch Wire with Solder Point Cover (3 Female + 3 Male) 3D Printer Power Supply

Yes however XT60 to PowerPole remains a bit of a unicorn out there in the land of ready-made PowerPole adapters. I don’t know why since both are popular, but that’s the case. The last time I

I have concluded that being a serious amateur astronomer means learning how to crimp connectors. So I've done Anderson powerpole connectors to accommodate the Mach2, Molex connectors for the

I could consider crimping up a bunch of XT60 to PowerPole adapters and making them available to the group.

I use these two cables (male and female), one for the power supply and one for the Pegasus Powerbox (Advance version). Note that the connectors are not mounted the right way for the Mach2, but it is

I have AP Mach2 and Pegasus Powerbox V2 and as it was difficult for me to find an XT60 cable (Powerbox) to Anderson Powerpoles (Mach2) I bought XT60, Anderson power poles and cable and I made myself

It sounds like the Mach2 has what I need - I have a Pegasus UPBv2 on the OTA that handles all the on OTA distribution. I use / need the internal routing to get a USB3 'backbone' to the UPBv2. The

I run my own cables through my 1100. I was worried about the more limited through the mount cabling ability of the Mach2. In the end, it has been a non-issue with the Mach2. With a Pegasus PB

Hi all, Real progress and some more questions using the ASI AIR PRO. First the good news, I used a FIDI USB cable and it connected the USB port to the ASI Air Pro first time. Now I can also use my

There is a single power connector and a single USB3 connector for through-the-mount cabling. My PC and power supply plug into the back of the RA axis, then I connect a PowerBox to the power and USB on

There are two cables in the Mach2, one USB3 and one 12 volt power cable. If you want to run your own cables, then the Mach2 is not for you. The 1100 mount has huge hollow axes in which you can run any

For some reason I just noticed that there is no mention of internal cable routing option for the Mach2 on the AP website. Please clarify - does the Mach2 have this capability or not? I'd be really

👍👌

We bought that property partly because of the dark skies, but I learned from this that dark skies are just part of the equation. It’s pretty hilly down there, at least for Ohio, and it’s hard to

My old firm had an informal competition for the most exotic location where a cap with our logo was photographed. We had photos from remote islands in the Pacific, tops of mountains, etc. One of my

Is this feature in the latest firmware update? i have the older keypad which i have updated for use with the gtocp5.

Drift compensation is not in APCC, but sky modeling is, and can be used to also create drift compensation for any and all points in the sky. Measuring the actual drift and then using that to create a

Is drift compensation a feature of APCC pro/APPM as well?

Roland, Impressive to say the least! Really enjoy seeing your experimentation results… not so scary versions of “watch this”!!! 😆 Pete

These will be added to the other mount keypads at some point. Roland