>>>I always open it directly. Thanks for the help! I do this too. I always have APCC running with ASCOM before starting up any apps have you tried auto-config now button on apcc for the ascom driver?

On Tue, Jul 19, 2022 at 09:21 PM, Brian Valente wrote: Chris - when you open apcc, are you opening it directly (i.e., clicking on apcc) or are you opening it via an external app like NINA, SGP, etc.

Chris - when you open apcc, are you opening it directly (i.e., clicking on apcc) or are you opening it via an external app like NINA, SGP, etc. where it opens up APCC and then it attempts to connect

Hi Bill, The rate values displayed in the UI are calculated from values read back from the mount. If the rate shown in the UI did not change, then the mount's rate did not change. If you are within

Ray, A little more information on this issue. It just happened to me again. APCC opened, connected to the mount but did not connect to the driver. No pop-ups, no error messages. I tried to close

That was exactly my thinking until Howard’s comments below. -Wade

Hi Wade, if you use a Model with APCC then the Ortho error is corrected. What you need is a Model on both sides east and west. Konstantin Konstantin v. Poschinger Hammerichstr. 5 22605

Are there any plans to expose configuring the orthogonality model via APCC or APPM? APPM collects samples near the zenith at both sides of the meridian, so it seems like it would be

As Roland said, the keypad and APCC can work well together. Remember, though, that the Keypad model and an APCC model can't interact or communicate with each other. Whether you want extensive

Hi Dale. Thank you for the detailed explanation. I thought it was odd that this option was included, which is why I asked. I can be quite confusing for users who don’t use TSX+T-Point. I know

>>>Why the Java installer did not associate the file with the Java platform by default is a mystery. Indeed! Software can work in mysterious ways to me sometimes :) -- Brian Brian Valente astro

IMO, the stainless steel sleeve may actually not be an improvement over the previous no-sleeve design. I have gone back to the original aluminum counterweight shaft adapter on my AP1100 that did not

Unfortunately, I was not successful. I had to use rubber strap wrench to full screw the counter weight shaft. About ¾ of the threaded shaft was muscled through to the end. I backed it out with rubber

Wade, Thanks for your assistance; I’m now up to date. Ted

I thought that I'd go ahead and weigh in on this as well. Last year, I spent some time with unguided imaging with an APCC Pro model. This was before dec-arc tracking was introduced.

Hi I spoke to Mike and he said there is no tuning available for a mount that does not have encoders. (Which it doesn't). So, he suggested that I check the gear mesh of the spur gears. You may recall

Thanks for the information. It seems like the simplest solution is to cut the stock cable and install PowerPoles so that I can use it either at the full length, or a short run.

Yeah, I just noticed a new part number and seems very difficult to find them on stock. Peter

Hello Peter, Hirose changed the part # to RM12BPE-2S(76). Since that change, vendors have not stocked them so we special order with long lead-times. Clear Skies, Marj

On Tue, Jul 19, 2022 at 10:18 AM, Ray Gralak wrote: Thanks, but I don't need any logs or additional testing for this issue. I can purposely polar misalign my mount to test the all-sky