I connected an MGBox v2 to my APCC laptop this week, and it is set up in APCC. Temperature readings are close enough but the pressure readings being returned are 90 mbar lower than of a half dozen

Quick follow-up: I replaced the USB to serial cable, and it ran all night without the aforementioned "freeze". So far so good. WB

Thanks Howard - will give that a try and report back!

Hi there, I've just realized why I cant change the button rate. My initialization window doesn't have a button rate box. I have uninstalled and reinstalled APCC but still differs. Any ideas? using

Hi Steve, It seems that your keypad has lost its programming and is now in firmware-load mode. I do not know how or why that would happen unless a reset procedure had been run. (We call the reset

Hey, When I powered up my AP1100 mount yesterday evening the keypad failed to boot - all I get is a single flashing red square in the upper left hand corner. It had been working fine the previous

Hi Dale Thanks for taking the time. That night I had upgraded to Beta right after, ran the same Frame ‘Slew and Center’, did the same thing. Since I was using my laptop to determine how APCC

Turns out that it pays to bring backup methods. We balanced an absolutely beautiful example of an A-P 155 f/9 and, as I was talking the faculty through PA'ing using the RAPAS, the batteries in the

Hi Michael, I'm just replying to this thread here. The DST time issue you described in the other thread would definitely have a bearing on this issue. In versions of NINA that are newer than what you

Sure enough, the keypad was in Connect=Yes mode and still on DST. I changed it to Connect=EXT. -Stacey

Thanks, I’ll read that through Cheers

I'm virtually certain it's the keypad. I haven't updated it since DST went off. I don't use it now anyway, so I'll just unplug it after shutdown. Thanks again, Roland.

PS Dale released a nice AP plugin for NINA, it's worth reading through it. you may not use the advanced features, but you can get an idea of how NINA can and will integrate nicely with AP mounts and

Hi Mike >>>What’s the best setting for NINA: Stop Tracking, Park Mount, Flip Scope, just warn. And what settings in NINA if any? That's kind of up to you on what you want to have happen. Horizon

I’ve mounted my 130mm refractor, just set my horizon and meridian limits. What’s the best setting for NINA: Stop Tracking, Park Mount, Flip Scope, just warn. And what settings in NINA if

The Eagle is a beast of a tripod. I would definitely buy an 8" version.

I'm not sure where the "DST" settings are but I'll look for them when I'm done imaging, esp. the keypad.

Thanks Lee, thanks Jeff, thanks everyone. A lot of great options here to aid in my decision.

Thanks , that might explain things I had problems earlier. I didn’t know that ASCOM had that feature

Check for DST in the keypad, ASCOM driver and APCC. Should be zero in all apps. Roland