I used Horizons for the first time after these changes on the JPL website and I get the same error, also the time format is 12hr off. I hope APCC Horizons gets fixed soon :-) Best regards, Geert

Chip, Thanks for responding. Impressive setup. I love how you made it not much wider than the dovetail saddle. How much weight do you think the mount is carrying? 90-100 lbs? How much

You said you have a problem with Voyager, right? I think Voyager software works fine here in the U.S. using a period as a decimal point, so it should be possible. -Ray

Another thought....Do you have a location for your observing stored in the HC and are you sure you are using that one. I have a few different sites saved in my hand controller so if you have the wrong

try removing both scopes and put a refractor on in standard position...centered instead of offset. See if that helps. With that much weight and I suspect not equally balanced side to side, that may be

The only problem with the decimal point adjustment is that I will not longer be able to use my automation software properly ! I will keep you posted as soon as I perform some test with a former

Good point. I did check and the last update was around August - so two month ago. I change lots of settings to minimize windows update... but as you mentioned, there are always some coming in.... and

Aygen, Your setup is behaving unexpectedly, so it is up to do what you need to get running. The problem seems to be with the ASCOM driver, not APCC. However, it is puzzling because this should be

Erkaslan Aygen wrote: Not to the best of my knowledge. I remember having upgraded about 3 weeks ago... I can try to install a former version just for sanity check... who knows ! The thing is I am

Not to the best of my knowledge. I remember having upgraded about 3 weeks ago... I can try to install a former version just for sanity check... who knows ! The thing is I am also getting the same

I guess I should have used the word "tinker-wise" lol... I actually have the special grease kit and plan to do a re-grease at some point here after I've finished tinkering with scopes and cameras.

Erkaslan Aygen wrote: Honestly, I don't know why all of this is happening all of a sudden. I didn't change anything software / drivers wise. Is it possible that Voyager changed, I know it gets

Good evening Ray, Honestly, I don't know why all of this is happening all of a sudden. I didn't change anything software / drivers wise. So, tomorrow I will install a former version (5.21.09 ?) and

Hi Aygen, You could go back to the old driver, but it's not clear to me why this version of the driver is not working, especially since you said it was working a few days back. Can you tell me what

Dear Ray, Dear All, I did apply thoroughly Ray's recommendation to adjust Windows regional setting to use "." as a decimal point rather than the "," that we have in Switzerland / Europe. Here are my

As for maintenance of an old legacy 900 GTO mount- no plans to re-grease the gears using the AP special grease kit 🤔 ??? Fernando

Responding to Scott, here are some photos of the tandem setup on my 900. The main saddle is a DOVELM162. The tandem plate is an SBD18SS, the C14 is on another DOVELM162, with a Losmandy C14 dovetail

I have a legacy mount, 900GTO and perhaps I've never pushed the equipment enough but I'm not sure how much more precision I could get that would even translate into better images. I purchased the

Christopher Erickson wrote: ...and most USB connectors and cables are junk. And it's getting harder and harder to actually get good ones. That's why I was so delighted getting this mount with

...and most USB connectors and cables are junk. -Christopher Erickson Observatory engineer Waikoloa, HI 96738 www.summitkinetics.com