If you think 130355FF would work with TEC 160FL, I would appreciate if you could calculate the back focus for this setup as well. Also would it fill a full frame camera like ASI6200MM or QHY600M?

Very cool, can you send me a picture of the shim? I need to move mine out a tad to make it blue.

I did some adjusting of the LED Cover on the Dec. Sliding it around would not make it turn green. However, I noticed that when I pulled up on it, it would turn green. So I took some thin brass shim

I cant seem to get WiFi enabled on my CP4. I connect via ethernet and web browser. I can see and change the ethernet IP from 169.254.x.x to an IP on my local network, so that part works. However, the

Happy New Year, Charlie, Moose, Tony, and All! Karen AP

Have a safe and Happy New Year guys. Charlie and little MOOSE are going to celebrate responsibly bringing in 2022 tonight :) I did a video showing the new Astro-Physics 1600GTO

When I built my observatory in the mountains of NM surrounded by a nation forest, the insurance company wanted me to separately list the items that cost more than $5000 each. Everything else was

It never hurts to uninstall APCC first from Windows control panel. You will not lose your settings or registration. -Ray

Hi George, can you please send it olso to me. Grüsse Konstantin v. Poschinger Hammerichstr. 5 22605 Hamburg 040/8805747 0171/1983476

Thanks so much Roland for the calculation! I just put a 13035FF on order along with the 16mm spacer. Thanks again! Scott

Can I install this version directly or do I need to upgrade to 19.0.11 first (I am currently using 1.8.8.17)? And I will try the other suggestions, thanks.

I have calculated the spacing required for the 140 TEC using the AP 130 Field Flattener, #13035FF. The distance would be 96.5mm measured from the back of the main flattener body flange without the

Mine is shipping out today. Call

Craig, The greasing concept for the 1200 and 1600 are, for the most part, the same. If you email me directly, I’ll send you the greasing instructions. Regards, George George

Karen, Given the current delays and increased cost with International shipping, it would be weeks to months before I would get the grease kit here in New Zealand. I did watch the video linked above

I noticed that:). Thanks for letting us know. Cheers Mike

Works great. Thanks again. BC

Thanks. Will try it. BC

Michael & Craig, Please call our office at 815.282.1513 if you'd like to order the grease kit. It is not available on our website. Karen AP

Hi Bill, No, it did not get promoted. There is an incompatibility between Eltima V10 and Windows 7, which required further changes. There were also additional changes to Horizons. Here are the links