Rolando, Thanks for the comments, which I appreciate. Last night I carefully focused prior to the run and we had good seeing. The run came out better but Ray found that one of my mount settings was

There are about 20 3rd party sites referenced on these pages. I noticed this when my various malware blocking programs block uploading files.

If you do more than 5 cycles you will see that the tracking rate in RA changes due simply to atmospheric refraction effects. So unless you change the basic tracking rate dynamically to a variable

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the ap-gto group. File : /Jerry's Calibratiion Files/Mount-Scope

Ray thanks very much, Indeed I had these setting correctly in there for the mount EXCEPT that the "Other" showed up on the Mount configuration. I have fixed that. Please see the screen shot

You need to add 3 successive runs, not 2 here, one there and 2 later. 3 successive runs will result in the curves lying close to each other and are not separated by polar alignment tracking errors and

That does not mean anything. It is a result of where in the cycle you started. Rolando

Hi Thomas, If you are still having a problem with the 3D View you probably should do mount/setup "sanity check". By that, I mean you should make sure that time/time zone, latitude/longitude are set

? https://smile.amazon.com/gp/product/B001M5PZMU/ref=oh_aui_search_detailpage?ie=UTF8&psc=1 Chris

May be this the problem? https://www.dropbox.com/s/pq0z6hi1dh22htf/Screenshot%202017-09-21%2023.15.16.png?dl=0 Mount Location - Time Offset -3:00:00 We have here at 51:37:24 N and 06:09:54 O UTC

Hi Joe, no limits set. Regards Thomas Am 25.09.2017 um 15:21 schrieb 'Joseph Zeglinski' J.Zeglinski@... [ap-gto] <ap-gto@...>:

By chance have you set APCC LIMITS, so that the option is set to Park themount at some Home coordinates or standard Park, when one is reached? Joe

Hi, Don’t know what you can do,since you realized that thedome and the concrete pier induce vibrations to the non-isolated pier. I would suggest you investigate “industrial

This is strange because the only programm which were able to send different position information could be the imaging software APT. This is as well the software where the plate solve software (ASPS)

sorry i am more precise: My 1100 Gto mount in remote has this new behaviour: If i send the mount to an object it lacks the object because after having slewed for a while turns in connected status but

Hi Jerome, First, you might want to update to the latest beta build, which is 2.99.41. You will not lose any settings: I think the biggest problem in this new pair of log files is that the correct

Since the dome mounting is coupled to the concrete base which the scope sits on, isolation may be difficult. Remounting the dome track on rubber blocks might work, but before investing so much

Actually unless the hand controller is configured to EXT thenit could be the second device/program I was talking about that could be givingyour mount conflicting information about where it is located

Hi Christopher, yes I do have an AP Handcontroller. Regarding your Information, my procedure was completely wrong to sync the 3D viewer Window with the position where the Telescope is pointing to in

My 1100 Gto mount in remote has this new behaviour: If i send the mount to an object it lacks the object and after having tracked for a while turns in not tracking and Skyx shows a bad position and