Will do Bryan, Thank you!! Steve

Steve Be sure to read the critical distinction between RCAL and Sync. page 58 in the Driver documentation http://www.gralak.com/apdriver/APV2_ASCOM_Driver.pdf and pg 113 in the APCC Pro

Hi Joe, "Form" is just the term for a "Window" in Microsoft's Visual Studio. That's why it was called a Form in the option. I've been experimenting with a few controls that can do what you are

Hi Ron, Ah, OK! Well, you're not alone. There's been a few times when I have been looking for something and despite that it's right in front of me, I don't see it. It's visible, but I think the brain

In the Keypad manual, I am not sure if it's spelled "RCAL" but look for "Re-calibrate" which is the same as RCAL. Happy New Year!!! Peter ---In ap-gto@..., <stevenhoffman53@...> wrote : Okay I'm not

Dear Ray, I updated all as instructed: https://www.dropbox.com/s/ovosp0snag4rs9v/Screenshot%202017-12-29%2018.17.48.png?dl=0 Because of bad weather conditions I wasn’t able to check the DEC

Okay I'm not familiar with the RCAL command. I will read up on it. Thanks Peter!! Happy New Year!! Steve

Good point, Ray. ********** I’m likely being picky, but ... Now that youmention it, why refer to it as a FORM ... which I relate to “something needed tobe fill-out”? I don’t. I suppose

BTW, so that I can make it easier for new users, assuming there isn't an undiscovered bug, what "tripped you up"? (e.g. it wasn't obvious that "form" means the application?). As a computer guru

I have a question. Why do you loosen the clutches to manually center the star and then tighten the clutches? You should be able to use the Keypad's NSEW directional buttons to accurately center the

My setup procedure includes placing the scope onto the well PA'ed mount, balancing it and positioning it in park3 by eye. Using APCC the mount is initialized and then using the hand controller

Hey Ron, On the setup tab in the "Program Operations" group, there is a checkbox called "This form is always on top". I think that "unchecking" that option is what you are looking for. If you think

Hey Ray, how to turn off "Always on top" of the main window. It's extremely annoying. Yesterday SGP popped up a window that I could not find... 10 minutes later I found it opened but APCC placed

Please call Astro-Physics on Tuesday so that we can provide you with the appropriate bearings. Clear Skies, Marj Christen Astro-Physics, Inc 11250 Forest Hills Rd Machesney Park, IL

Thanks Steve, I don’t remember increasing the font size but who knows. It took days for the original post to make it and by then Ray had already set me on the straight and narrow. Go figure….

While I had my 900GTO apart to re-grease the worm wheels and gears, I noticed that my RA worm gear bearings feel rough while rotating the worm gear. The bearings are stamped with 607z which only

I had the exact problem after increasing the size of theWindows default font. After reverting back to the original Windows font size the problem was fixed. steve hoffman

Hi Thomas, It looks like your software and firmware are out of date. Please update to the latest available CP4 firmware, and also the latest APCC/Driver versions. Then, retry setting the declination

I’ve run my mount at minus 15-20 c at an altitude of 16000 feet . Btw most drones will not take off more than 5 feet high !! Due to low pressure and water boils at 65 c ! Mach 1 rocks Suresh

Hey to all, after around 6(!) weeks of no clear sky we had tonight almost good conditions. Few days ago I installed a new setup with a side by side telescope installation. After a successful plate