Same computer or a different one? -Steve

Thanks Ray. Yes I had rebooted and cycled the camera with no change. I then swapped cables with the guide camera and got no change. This morning, I set up on the bench and everything is working just

Gary, I have a pelican 1640 case. The case also allows me to include the counterweight bar in the case with an additional 2" of lower density foam around the original AP higher density packing

No problem. I double checked the retaining nut tightness and it is snugged down tight (never loosened it). The screws holding the assembly to the back plate and the plate to the main housing are also

Are you sure you have MaximDL selected as the camera in APPM? After looking at the APPM source code the message in your log snippet should say include MaximDL in the message. If you continue to

MaximDL, yes.

The error is coming from the camera control application. Which camera control are you using? MaximDL? -Ray

Got this fail to connect camera message last night in APPM. Camera opens fine running Maxim direct. Any ideas? Camera is ASI6200mm.

Update: I tried both suggestions, the loading a backup configuration and the "Now" button in Auto-Config and it worked. Now the driver can be launched from APCC again.

On Thu, Aug 4, 2022 at 05:59 AM, Ray Gralak wrote: They are ok to use, but using APPM might be a little more accurate because it will use the environmental settings for the refraction calculation. You

A very nice image, Stacey. I imaged the Pelican in color three years ago, and last night got 5-1/2 hours of H-a to add to it. Here's the result: <http://astronomy.mdodd.com/nebulae-20.html> Looking

I did guide with an off axis guider. I haven't yet done an APPM "run" with my Mach2.

They are ok to use, but using APPM might be a little more accurate because it will use the environmental settings for the refraction calculation. You might consider using APPM for the first RECAL of

Thanks for sharing Stacey - that’s beautiful and a lot of data in a short time! Did you guide and use APPM? Thanks, Bob Robert J. Enouen Cell 513-504-4410

Very nice 👍

Rick, Which case are you using to store your mount. Thanks! gary

BTW, are you exiting APPM after finishing a model as it connects to the mount and is separate to APCC and will hold up the ASCOM driver

Thanks! Sorry I deleted the message. I had originally intended it for our local club. You folks are fast so here’s the link again for those who are trying to figure out what’s going

Good tip Ray. I'll notice that in the future. Thank you, -chris

Hi Chris, More likely, there may be a bug in one of the client applications you are running. Specifically, an application may not be disconnecting from the driver before closing down. The "clients"