A very nice image, Stacey. I imaged the Pelican in color three years ago, and last night got 5-1/2 hours of H-a to add to it. Here's the result: <http://astronomy.mdodd.com/nebulae-20.html> Looking

I did guide with an off axis guider. I haven't yet done an APPM "run" with my Mach2.

They are ok to use, but using APPM might be a little more accurate because it will use the environmental settings for the refraction calculation. You might consider using APPM for the first RECAL of

Thanks for sharing Stacey - that’s beautiful and a lot of data in a short time! Did you guide and use APPM? Thanks, Bob Robert J. Enouen Cell 513-504-4410

Very nice 👍

Rick, Which case are you using to store your mount. Thanks! gary

BTW, are you exiting APPM after finishing a model as it connects to the mount and is separate to APCC and will hold up the ASCOM driver

Thanks! Sorry I deleted the message. I had originally intended it for our local club. You folks are fast so here’s the link again for those who are trying to figure out what’s going

Good tip Ray. I'll notice that in the future. Thank you, -chris

Hi Chris, More likely, there may be a bug in one of the client applications you are running. Specifically, an application may not be disconnecting from the driver before closing down. The "clients"

My goodness, that's nice!

Very nice. Roland

Ray, Every time I've had thus issue I've never had anything connected to the driver. I always close everything before closing apcc. There is a bug either with apcc or ascom. The only way to resolve

Congrats on a very nice result, Stacey! Karen AP From: main@ap-gto.groups.io <main@ap-gto.groups.io> On Behalf Of Stacey Mills Sent: Wednesday, August 3, 2022 8:47 PM To:

The driver cannot close itself if an application is still connected to the driver. Also, if you "kill" an application connected to the driver, or that application crashes, then the application never

Thanks Joe! Glad you enjoyed it. The 160ed has been a treat. Just added a tilt and backfocus adjustment device and changed the wheel out to the new Pegasus Astro wheel, and just barely was able to

On Wed, Aug 3, 2022 at 09:22 PM, Chris White wrote: One more thing to consider, is that it might not be an issue where the driver didnt close properly from a previous sessionIf it's ascom that keeps

On Wed, Aug 3, 2022 at 03:59 PM, Chris White wrote: I had the same problem for a while and reported it. It happened again last night. What happens is the v2 driver is not closing properly from your

On Wed, Aug 3, 2022 at 06:54 AM, Ray Gralak wrote: The model will work okay in this case. Doing a RECAL from APPM will synch the mount into the model.Is it necessary to do the RECAL from APPM? Or is

Thank you all, I will try what you suggested next time.