I have experienced the same issue and unfortunately use Pempro only on a mission critical task of identifying the periodic error and programming the mount. Even then, it is a huge hassle only using

Unfortunately the ZWO ASCOM Camera driver is extremely memory inefficient. A single unbinned full-frame image from your camera will require well over the 1GB graphics maximum memory available to

On Mon, Mar 7, 2022 at 08:59 AM, Ray Gralak wrote: The new release does not eliminate the Eltima virtual ports but provides an alternative if you cannot get the virtual ports working on your

It rides on my Mach 2 like nothing is there, it also sports the 8" AP Rings, SBD12 from AP, and the 8" AP Vixen dovetail bar as a handle. 🙂

Its a nice lightning fast F3.3 Astrograph with a well-corrected field that will cover the IMX455 no problem. It has a 3-micron spot size from center to edge! Mine looks much different now though, I

Holy Moly Rolando

Thunder banana?? Rolando

Ive never been to Hawaii, now may be a good time. My thunder banana (Epsilon E160ED) is hungry.

Sure. We got nice dark skies just about every night. Rolando

Sweet image, can I come over and borrow some sky? 🙂

https://www.astrobin.com/eo36tl/0/ Having fun with 305 Honders in our Hawaii observatory Rolando -- Roland Christen Astro-Physics

Hello Ray, The camera is an ASI6200mm pro, and the frame size is already set to center 1/2. Just to be clear, this setup has been working since the mount was installed here in August. Last night was

The error is "insufficient memory". What kind of camera is this? You might try configuring the Camera Frame Size to "Center 1/2" or "Center 1/3" on the Camera Information page (Step 2 of 9). -Ray

Mike, You’ll be fine with the standard encoders…we use them here in Illinois. Regards, George George Whitney Astro-Physics, Inc. Phone: 815-222-6538 (direct line) Phone:

Updated PEMPro software last night then had attached problem running polar alignment wizard. At 9:37, it takes the fit image, then stops with the memory error message. There is no memory error on

On Mon, Mar 7, 2022 at 09:26 AM, Ray Gralak wrote: And you don't need to use ports 20 and 21 - any unused port number will work.But especially if you already use ethernet to connect to the mount,

Hi Larry, APCC creates and destroys virtual ports as needed. If you kill APCC or reboot without closing APCC first, APCC will not get a chance to close the virtual ports it created and those virtual

Ray, I had been doing some offline testing of a couple of automation software. In the process, APCC decided to use different virtual ports. When I went back to connecting online it would no longer

Hi Terri, The new release does not eliminate the Eltima virtual ports but provides an alternative if you cannot get the virtual ports working on your computer. So if you update to the newly released