Hi Ray and AP community, As promised, I had the chance to test the new version. It seems to work like a charm ! I did only a couple of slew / center / syncs and I haven't received a sigle warning /

Perhaps Wes but I would not recommend it. But I DO recommend the boards be installed by AP if your mount can take them. My Parallax 250 Observatory mount uses the AP servo system. It's a good 12 to

Wes, I don't know. I asked that question because I wanted to do it myself for my 400 mount. Unfortunately, they don't have an ESD board for this mount so I never found out. Thanks, Scott

Bryan, Regarding ASTAP plate solves, you can look at the APPM logs to see the command line arguments passed to APPM. If you set all of ASTAP values to zero in APPM’s plate solve tab and check

Ray Thanks for the new BETA 1.9.1.3. A few comments follow. Your insight IS appreciated. I hope these are helpful to others. · Program installed without issue. (1100 GT non-AE) ·

Should I install CP4-P01-14 in CP4 so I can re-install keypad 4.19.3? If successful, I then can re-install VCPx-P02-08 in CP4? Peter

https://www.astro-physics.com/software-updates/ Scroll down a bit. Peter

Hi Marty, Unfortunately, there is not a TPoint translator nor a way to manually select stars at this time. What is the field of view of your setup and pixel dimensions of the sensor? -Ray

Version 4.19.5 keypad firmware is available for download? Is this a recent development or did this happen many moons ago? I thought 4.19.3 was the current version- guess I'm wrong about this. Fernando

T-point cannot provide dual-axis tracking with AP mounts…only APCC can do that. Regards, George George Whitney Astro-Physics, Inc. Phone: 815-222-6538 (direct line) Phone:

I use APPM with great results on my Mach2 with the 130mm refractor. I have been unable, after a year of effort, to build a APPM model on my 1100 with the 300mm f/15 Cassegrain. The FOV and the pixel

Is it possible for the board to be installed without sending the motor assemblies back to AP? How much does this addition cost? Wes WA5TKU

It's not possible for me to call with a telephone because I am deaf. I cannot use TTY because I don't have landline. TTY is not possible with cell phone. It appears that the Keypad Loader is working

Peter, I agree and made a note to do so. Clear Skies, Marj Christen Astro-Physics 11250 Forest Hills Road Machesney Park, IL 61115 Phone: 815-282-1513 www.astro-physics.com

Peter, Give Howard a call on Tuesday for assistance. Clear Skies, Marj Christen Astro-Physics 11250 Forest Hills Road Machesney Park, IL 61115 Phone: 815-282-1513 www.astro-physics.com

Yes, my CP4 firmware version is P02-08. Peter

Hi Suresh, I am using USB cable from USB port of CP4 to PC's USB port via powered USB hub . Device Manager says this port was assigned to COM 3 port. Peter

Peter , I did that two years ago had hell , I’m trying to recall how I finally did it. If im not mistaken it was a cable issue . How do u connect to the pc ? Suresh

Hello, I've been trying to upload Keypad version 4.19.5 firmware to my Keypad that was previously version 4.19.3 but no success yet. The first two times I tried to upload Keypad version 4.19.5 to my

Mike, Thanks again. The method worked perfectly. I have been using this feature of the V5 Keypad since I set up anew each night for the most part and found that my cone error changed slightly night