Should I install CP4-P01-14 in CP4 so I can re-install keypad 4.19.3? If successful, I then can re-install VCPx-P02-08 in CP4? Peter

https://www.astro-physics.com/software-updates/ Scroll down a bit. Peter

Hi Marty, Unfortunately, there is not a TPoint translator nor a way to manually select stars at this time. What is the field of view of your setup and pixel dimensions of the sensor? -Ray

Version 4.19.5 keypad firmware is available for download? Is this a recent development or did this happen many moons ago? I thought 4.19.3 was the current version- guess I'm wrong about this. Fernando

T-point cannot provide dual-axis tracking with AP mounts…only APCC can do that. Regards, George George Whitney Astro-Physics, Inc. Phone: 815-222-6538 (direct line) Phone:

I use APPM with great results on my Mach2 with the 130mm refractor. I have been unable, after a year of effort, to build a APPM model on my 1100 with the 300mm f/15 Cassegrain. The FOV and the pixel

Is it possible for the board to be installed without sending the motor assemblies back to AP? How much does this addition cost? Wes WA5TKU

It's not possible for me to call with a telephone because I am deaf. I cannot use TTY because I don't have landline. TTY is not possible with cell phone. It appears that the Keypad Loader is working

Peter, I agree and made a note to do so. Clear Skies, Marj Christen Astro-Physics 11250 Forest Hills Road Machesney Park, IL 61115 Phone: 815-282-1513 www.astro-physics.com

Peter, Give Howard a call on Tuesday for assistance. Clear Skies, Marj Christen Astro-Physics 11250 Forest Hills Road Machesney Park, IL 61115 Phone: 815-282-1513 www.astro-physics.com

Yes, my CP4 firmware version is P02-08. Peter

Hi Suresh, I am using USB cable from USB port of CP4 to PC's USB port via powered USB hub . Device Manager says this port was assigned to COM 3 port. Peter

Peter , I did that two years ago had hell , I’m trying to recall how I finally did it. If im not mistaken it was a cable issue . How do u connect to the pc ? Suresh

Hello, I've been trying to upload Keypad version 4.19.5 firmware to my Keypad that was previously version 4.19.3 but no success yet. The first two times I tried to upload Keypad version 4.19.5 to my

Mike, Thanks again. The method worked perfectly. I have been using this feature of the V5 Keypad since I set up anew each night for the most part and found that my cone error changed slightly night

John, I used to use Platesolve 2 all the time as well, but switched to ASTAP. It’s free, is WAY faster at solving, and just seems to work better. You should give it a look and try it. Plus, I

This should be mentioned in A-P manuals either in Mach2 or Keypad documentations. This is useful information. Peter

All, If anyone has a 900 or 1200 mount and perhaps other older GTO mounts, AP is offering an Electro-Static Discharge board to be installed in the motor-gearbox assemblies. The Dec motor on my 900

Last night, my new AP1100 (base) peformed great on very windy night. I got the AP1100 a couple of weeks ago, and I am very early on the learning curve. Per George's recommendation, I have yet to try

Hi Steve, It doesn't work that way. The mount's flip point is controlled by the meridian delay set in the mount. The cause of the flip failure is probably a time discrepancy between the mount's