michael mccann wrote: My understanding is that NINA records the FITS headers from what the mount is reporting at that time. You can double check by looking in the equipment tab while taking a

Hi John, You don't need to capture a "good" ortho model to "erase" it. Just run the keypad procedure, but do NOT make any N-S-E-W centering corrections. This will produce an ortho model with zero

I learned there was a problem while I was learning PI PhotometricColorCalibration process and the tool kept failing on my M33 image. I resolved the coordinates and found my fits header’s RA and DEC

Hi AP folks, I have a follow up question related to a previous thread I started a few months back. (Interactions Between Keypad and APCC Orthogonality Models?) In that thread, Roland said "the

Hi Ray, >That's not going to work because you can't guarantee that SGPro won't issue a slew after the meridian. That's fine as this is exactly the expected and documented behavior for SGP: If the

Got a model built using ASTAP with Beta 1.9.1.3. Did not work at bin 2, but did work at bin 1 with min star at 1.0. Thanks Ray. BC

Ok, thanks Ray.

Honestly, I'm pretty busy working on software now. But I don't think there is anything to discuss. APCC sends the mount's flip point to SGPro, which is exactly what SGPro expects. Changing the

It might be more efficient if we could talk. Would you be willing to send your phone number and time to talk to my email address listed?

That's not going to work because you can't guarantee that SGPro won't issue a slew after the meridian. Without APCC actually setting the meridian delay SGPro would not expect the mount to flip if it

Ray, I am not sure why I can't communicate the issue to you properly, but I will continue to try. I don't want to check the CW up slew west box. I do want any slew command issued by SGP past the

"CW up slews" invokes APCC to change the meridian delay. With it off, the appropriate action will be taken when the limit is reached, but any slew to the West side from a counterweight-up position

I have posted a couple of times about Meridian Flip issues with APCC v1.9.0.11 and Sequence Generator Pro. This worked reliably for several months with the previous version, but I now think that was

Thanks for the confirmation Roberto. I was assuming that would be the case but thought I'd check with someone who has more experience with it. My setup is quite compact and I've done as much as I

Joe I doubt the mount will notice the difference; I would not worry. I have changed my Vario finder/guider a number of times as I add/change my tandem setup and the guiding is as good as ever (been

I was looking for user experience on the 10x60 Baader guide scope with Astro-Physics guider bracket and wondered if there is any potential need for special balancing when it is side mounted to the

Hi Alain, APCC executes Eltima's installer as part of the installation process, but has no control over the Eltima installation itself. I think the issue may be a conflict between the version of

Hello Ray, i'm ahead of the search for the error and ... i believe that the Eltima's driver isn't installed An idea ? Regards, Alain

Good morning Ray, Wahhh, thank you for letting me know. I will install it right away and give it a try as soon as the weather clears up. Keep you posted. Best regards, Aygen

Hi Aygen, If you want to give this new version (v5.40.00) of the AP V2 driver a try, I think it might fix the issues you have been