@Bill Long wrote: Post your model tab data. Curious to see your results. Sure. This is with an NP101is still s, short and light and shouldn’t have much flex, but this was only 37 points,

Had to take a break but should be back in the swing tonight with this combo. I took Rolands advice and neutral balanced both axis on the Mach 2. Here is a photo of the beast in route to a fun

Post your model tab data. Curious to see your results.

ASCOM Camera just throws the same errors he mentioned when used directly. The SIM might work but a real camera doesn't seem to.

Ray said: It's too bad you couldn't get around to proving APPM's ASCOM interface also works with the ASCOM Camera Simulator, as I know it does. Here's a screenshot as proof: J I will. I

I'm glad it's working! It's too bad you couldn't get around to proving APPM's ASCOM interface also works with the ASCOM Camera Simulator, as I know it does. Here's a screenshot as proof: J

As a minor update, I had a bit of time before my target was high enough after I got all the other setup done so... I set up TSX, Image link and APPM so that APPM used TSX's Camera, which used my

You can easily prevent SkyX from starting by changing the platesolver to PinPoint. Please try again and set the attached image to the image in the Camera V2 Simulator. BTW, you're connected

***SOLVED*** I did some investigation and testing after reading about how some other folks have had similar Wi-Fi issues with the CP5. I made several incremental settings changes to my home mesh

@Ray Gralak wrote: Please close down SkyX *completely* so that it will not interfere. Despite what others have said, not all ASCOM camera drivers work when there are two applications connected. (As

Please close down SkyX *completely* so that it will not interfere. Despite what others have said, not all ASCOM camera drivers work when there are two applications connected. (As far as I know, SkyX

I'll try ASCOM Camera out later this evening as I'll be touching up my PA and running a new model on my Mach 2 / AGO 12.5 combo after pulling the cover off and waking it up from it's slumber during

Thanks Ray, but I remain confused. I did exactly that with TSX, set up the camera simulator after saving a M31 image from last night resampled to a third size to stay under the limit. It worked

I use my cameras via TSX to do APPM models since I use TSX for image link solving for APPM anyhow. I've never used the ASCOM Camera option.

Hi Linwood, APPM just displays whatever is provided to it via the ASI ASCOM driver. Have you tried using APPM with the ASCOM Camera V2 Simulator? You can supply a jpeg image to be displayed.

One last observation, More often than not after a power cycle (power off, wait 2 min, power on, wait 2 min) there would be no networks available on the Wi-Fi Network Connection Selection settings

As a follow up: After tinkering around I was able to connect to my home network, but I didn't do anything different. Then I noticed this odd behavior: 1. The Wi-Fi connection would only show up in

I'm confused. I have an ASI6200MM. I have the latest ASCOM drivers installed. I realize APPM is 32 bit and so struggles, so I have it set to bin 2, subframe 1/2x1/2 center. If I don't use a

I've been using the CP5 Wi-Fi successfully for several months now. My primary method of connectivity to my PC is serial over USB, but I always connect the CP5 to my home Wi-Fi network so I can simply

I've had my 1100 for a few months and it has performed well. However I noticed from day 1 a small amount of free movement in the RA axis while the Dec axis has none. The amount of play in the RA