Thanks Karen. I just uploaded The finish imaging to the gallery section. Was able to add SII. So now it is a completed hubble color

John, I just tried unparking from Park 3 and using the move buttons to move more than 10 degrees from (Park 3 dec = +89 59 59) See attached image. -Ray Gralak Author of PEMPro Author of APCC

Aloha Ray, ok, I'll get some screen shots sent over to you. I'll just put them all in a MS Word doc. I was connecting to it again today, but it's still doing the same thing. The only thing new

Hi John, I finally had a chance to go through your logs, and unfortunately, I cannot find any indication of the behavior you were seeing. How about trying this again and taking a screenshot of what

Nice tight stars!

I Need the width and thread size of threaded top end of 1.875” counterweight shafts. Thanks in advance, Mark

Roland sets up something similar during the indoor final testing phase for each Mach2GTO. It is a bit of a chore, but has deepened his understanding of this mount. Clear Skies, Marj

Press +- and then 9 and you will see the meridian features. Rolando

Ok, we'll get back to you and take a look at your mount. Rolando

They look like they did more than just try. I hope they got what the each wanted for Christmas. They deserved it! Bryan

I am very careful about checking balance and recheck it when I change cameras. I think it is right on. I also remove the somewhat heavy scope front cover from the Planewave even if it is not the scope

Nice picture! Lee

👍😀🔭 Get Outlook for iOS

They both got Astro-Physics equipment Pete :) tony

Ha! Ha! Ha!! Merry Christmas!! JimP Get Outlook for iOS

Merry Christmas Tony 🎄 Hope Santa 🎅🏻 was good to Charlie and Moose! Pete

Anytime sir. Merry Christmas!

Thank you Bill / Rolando. Rolando I downloaded and installed the latest version of the keypad software (4.19.3), but I cannot see the meridian flip feature. How do you perform or access the feature

Wow! Just setting it up must have been quite a chore. I suppose you have to wash dishes for a week after taking this picture. Merry Christmas to you and Marg and the rest of the crew at