Thanks Paul One of my other reasons for choosing an AP900, was that it could be separated into RA and DEC sections, and each one would be lighter than the full Losmandy G11 mount. As the years

"Joseph Zeglinski" <J.Zeglinski@...> wrote: Company 7 makes some very nice ATA cases. There are some pictures of my 900 cases in the files

foamed cases also have post was pack the I can certainly vouch for how well all AP equipment is packed prior to its departure from the AP premises. I have an AP160, an AP1200GTO and an AP Mach1GTO

Hi Ray, one question please. Having checked all the settings in PEMPro and the ASCOM settings, I discovered that the "PEM Playback" check-box in the ASCOM settings was checked. Would this

richard.kinsey@... writes: The way the servo works is that it will do whatever it is commanded from whatever source. If the keypad is set to PEM off, this is a one time command that is

Good point......... In my previous post about using Sterilite containers for mount cases, I didn't mention that when empty, they weigh almost nothing. With the poly foam liner they might weigh 1-2

richard.kinsey@... writes: The factory curve only plays when you turn PEM to Playback in the keypad tools section. Otherwise it just sits in memory and is not

A question and a suggestion: Yes, ATA, Scopeguard and etc. type case are wonderful..........but expensive. So, I have to ask, what is the intended use of your mount and therefore the cases: ie. Do

J.Zeglinski@... writes: We would recomend Scope Guard cases for your mount. They have a case for each of our mounts, and they are rugged and airline

Rolando, many thanks for your message and advice. Can I please ask thay you clarify one point. Am I right in assuming that the factory installed lab PEC data only play's when PEC is enabled via the

Sorry, Rolando, That was not at all what I intended. My AP900 arrived quite well packed. However, I can't use the original cardboard box in the field forever, so I am considering what will be

Congratulations Marj, and I look forward to the expanded production as I wait eagerly for a Mach 1! Dave

Hi Ray, yes, I have only been using PEMPro to record the PE. I haven't downloaded any information to the mount, so the original PEC data should be retained. I will do as you suggest, but can you

BTW, here is the help for the final programming step (same as the help included with the application): http://www.siriusimaging.com/Help/PEMProAP/ProgramMount.htm -Ray

Congratulations on the review. Nobody on this forum is going to be surprised. SOP for AP. Harold using the Mach1GTO since late 2006 (the mount was from the first production run). You may recall that

Harold, They sure did! The review is excellent! Dennis di Cicco has been using the Mach1GTO since late 2006 (the mount was from the first production run). You may recall that he reviewed the

Hi Dean, If the PE gets worse after uploading the curve try inverting the curve and uploading it to the mount. -Ray

Hi Richard, Just to be clear... you are using PEMPro only to measure the PE, correct? If so, it may just be that was loaded into the mount needs to be inverted. Just use PEMPro to download the

Not having seen the review, but based on my experience with a 900, I will take a wild guess. They liked it. Harold has just copy today (and

I am having trouble getting Pempro2 working the way it should, maybe I am just not sure how to use it. It seems a lot worst when I turn it on after running through the process. But with it off, I