Re: AP1100 Play in Dec Axis #Guiding


Roland Christen
 

Little Moose ok, BIG Moose, no! Smile

Rolando



-----Original Message-----
From: Harley Davidson <astrocnc@...>
To: main@ap-gto.groups.io
Sent: Sat, Apr 23, 2022 2:42 pm
Subject: Re: [ap-gto] AP1100 Play in Dec Axis #Guiding

Roland

Would a "little MOOSE" be okay to use (as shown below) to tighten those screws :)

tony


On 4/21/2022 11:54 AM, Roland Christen via groups.io wrote:

Can I have overtightened the 8x bearing bolts?
You problem appears to have been loose clutches.
Overtightening the 8 screws is not an issue unless you used an 8ft cheater wrench with a Moose pushing on the end.

Rolando

-----Original Message-----
From: Rouz <rbidshahri@...>
To: main@ap-gto.groups.io
Sent: Thu, Apr 21, 2022 10:17 am
Subject: Re: [ap-gto] AP1100 Play in Dec Axis #Guiding

I tightened the 8 Dec and Ra bolts. they were pretty tight to begin with.
  •  
  • I then tightened the clutch knobs all the way down with an Allen key.
  •  
  • The gap on the dec axis no longer opened up and the Dec' plate was parallel  to the axis which is good news.
  •  
  • However, making a model (same points as before) showed the error to much worse.

I did change the camera configuration so the balance was off:

  1. I'm not sure if the balance being off caused such a larger error? (will rebalance and try again)
  2. Can I have overtightened the 8x bearing bolts?



--
Roland Christen
Astro-Physics

--
Roland Christen
Astro-Physics

Join {main@ap-gto.groups.io to automatically receive all group messages.