1. Ap-Gto | Main
  2. Messages

Re: VPort2 / Fault / Sync Target: Valid Alt/Az, RA/Dec, HA/Dec has not been received!"

Ray Gralak
 

Hi Aygen,

That error message means that one or both sync coordinates (RA/Dec) have not been received, so the sync cannot be completed.

Can you use APCC's Log Zipper utility to create a Zip file with your APCC and AP V2 ASCOM driver logs and post a link to the zip file? (And, please do not attach the zip file to your post as it will be too large).

-Ray

-----Original Message-----
From: main@ap-gto.groups.io [mailto:main@ap-gto.groups.io] On Behalf Of Erkaslan Aygen
Sent: Saturday, October 16, 2021 1:13 AM
To: main@ap-gto.groups.io
Subject: [ap-gto] VPort2 / Fault / Sync Target: Valid Alt/Az, RA/Dec, HA/Dec has not been received!"

Good morning,

Since a fews days I am experiencing an issue and I hope that someone could help me in solving it. I keep
having the following error message every time I sending a command to my acquisition software (Voyager) to
center a target : "VPort 2 / Fault / Sync target: Valid Alt/Az, HA/Dec has not been received"

My equipment, in a nutshell :



* AP 1100 GTO CP4
* Firmware VCP4-P02-10
* Connection type : TCP + backup port. NOTE: my ethernet cable transits via a "Neatgear Hub"
* ASCOM Plateform 6.5 SP1(6.5.1. 3234)

As can be seen on the below image, I don't have any problem to connect to APCC nor to the AP driver.
However, as mentioned, I keep having the above mentioned error message for a couple of days and I don't
know why ! I did not change anything nor installed any W10 updates.

Also, I have already reinstalled the APCC and the AP driver but the problem persists :(

I would appreciate your support.

Best regards,
Aygen
Join main@ap-gto.groups.io to automatically receive all group messages.