Re: APCC move axis question

Ray Gralak


Are you sure you have the correct log file? I don’t see any of the tracking rate debug output. In fact, the log indicates there is no tracking rate correction.

And can you please use the APCC Log Zipper instead of the ASCOM log zipper? You can run the APCC log zipper from APCC's tool menu.



-----Original Message-----
From: [] On Behalf Of Andy Ermolli
Sent: Tuesday, August 31, 2021 4:45 PM
Subject: Re: [ap-gto] APCC move axis question

Here are my most recent logs. I tried move axis with NINA and tracking corrections enabled in APCC.
I pushed each direction button for about 15 seconds. The move axis speed was set to 3 degrees per second.
NINA 64 bit 1.11 nightly #135.
AP Mach1 GTOCP3 with V2 chip. The mount did not move.

Join to automatically receive all group messages.