…And now that I’ve seen it work with the ASCOM test app, it’s now working correctly with APCC. I love it when a problem disappears on its own (sarcasm).
The only thing that I can think of, is that perhaps the ASCOM test app made some change to the configuration. I’m just grasping at straws now, but I would love to understand what actually happened, so that I can correct it when it (inevitably) happens in the field when I have no contact with the outside world.
Yes, I am connecting to “ASCOM ObservingConditions” as the source.
In the “Select Driver” box, I have tried “ASCOM.OCH.ObservingConditions”, followed by setting the ASCOM driver for the MGBox V2 in the appropriate properties for the observing conditions hub. I have also tried selecting “Astromi.ch MGBox Observing Conditions” in the Select Driver box.
Both methods give the same results.
I have also tried enabling “Trace on” in the MGBox driver, but I haven’t figured out yet where I can go to read the trace.
Finally, I just found the ASCOM “Observing conditions Hub test harness”. When I run that tool and connect to the observing conditions hub, it shows the correct information (below). I was originally thinking that this would probably be a problem with the MGBox ASCOM driver (and I asked about it here to see how others were getting it to work with APCC), but now I suspect that it actually *is* an APCC problem, since the ASCOM test app works correctly:
5/28/2021 8:54:41 AM
ASCOM Observing Conditions Hub (OCH). Version: 126.96.36.199
AveragePeriod : 0.0
CloudCover - This property is not implemented
DewPoint : 2.7
Humidity : 34.0
Pressure : 933.8
RainRate - This property is not implemented
SkyBrightness - This property is not implemented
SkyQuality - This property is not implemented
SkyTemperature - This property is not implemented
StarFWHM - This property is not implemented
Temperature : 18.9
WindDirection - This property is not implemented
WindGust - This property is not implemented
WindSpeed - This property is not implemented
CloudCover is not implemented
DewPoint Description : MGBox uses a Bosch BME280 sensor
Humidity Description : MGBox uses a Bosch BME280 sensor
Pressure Description : MGBox uses a Bosch BME280 sensor
RainRate is not implemented
SkyBrightness is not implemented
SkyQuality is not implemented
SkyTemperature is not implemented
StarFWHM is not implemented
Temperature Description : MGBox uses a Bosch BME280 sensor
WindDirection is not implemented
WindGust is not implemented
WindSpeed is not implemented
Under Data Source have you selected Ascom?
On Fri, May 28, 2021 at 8:36 AM W Hilmo <y.groups@...> wrote:
In my quest for unguided imaging, I've picked up an MGBox V2 so that I can get temp, pressure, humidity and dew point.
I have installed the MGBox V2 and verified that it is working correctly in its own application. I've also installed the ASCOM driver 1.6 for the MGBox V2. The problem is that I cannot get it to work correctly with APCC. All of my attempts to test it cause APCC to display -237.2C (absolute zero) for both temperature and dew point, and zeros for pressure and humidity. I have tried connecting directly through the ASCOM ObservingConditions selection in APCC, and also by connecting to the ASCOM Observing Conditions Hub and selecting the MGBox V2 for the relevant specific devices.
Does anyone have any suggestions or troubleshooting steps to figure this out?