Re: Strange guiding errors with AP1200


Roland Christen
 

The RA worm turns once every 6.4 minutes and so if there was a piece of dirt embedded on the worm teeth, there would be a jump in that time frame. If it repeats forever, then I would suspect a damaged worm. If it happened just once in the same place in the sky I would suspect a damaged tooth on the main worm wheel.

There could also be a piece of dirt embedded in the final spur gear that's attached to the end of the worm. That can be easily cleaned, but that would show up for every 6.4 minute cycle and would not go away.

The fact that it showed up in Dec is probably due to a bad calibration run. Dec axis probably did not move, but the guide software is interpreting part of the RA error as a Dec error.

I would remove the RA gearbox, clean all the grease off both the worm, the main worm wheel and all the transfer gears inside the gearbox. Then re-grease every thing.

Rolando



-----Original Message-----
From: Allen Gilchrist via groups.io <gilchrist.allen@...>
To: main@ap-gto.groups.io
Sent: Thu, May 6, 2021 4:44 pm
Subject: [ap-gto] Strange guiding errors with AP1200

Has anyone else seen anything like this before?  During an imaging session with my AP1200, while guiding with an STi on a 400 mm f.l. 80 mm refractor, I noticed an occasional really large guiding error.  It took a few cycles to bring the guidestar back to the center of the guide window, and then all was OK until it happened again.  I started an autoguider log file, and found that the process repeated every 379 sec.  This suggested some problem in the RA drive system, but there were corresponding spikes in the Dec. error log as well.  In fact these errors were larger than those in RA.  It almost looked like something was binding the RA drive every 379 seconds and then, when the drive slipped free, there was an impact on the Dec axis.  Interestingly, after recording five of these events in the autoguider log, the problem vanished.  I continued observing for about another hour and a half but the problem did not return.  I've attached a couple of plots, one showing the problem, and the second one after the problem went away.  The plot scale is in pixels, and each pixel is 3.82 arcseconds.  Any ideas?

Allen

--
Roland Christen
Astro-Physics

Join main@ap-gto.groups.io to automatically receive all group messages.