I have an AP900 setup in my observatory and the pier is tall enough that I need the scope to parked in a specific position to prevent it from interfering with the roof (and also to point to the wall).
Using APCC standard, I have configured the correct position and it is working well and accurately.
The problem is, with SGP, I want to park to that position each time and it connects to the AP ASCOM V2 driver. The AP ASCOM V2 driver has only "Current Position" , "Park 1 to 5" and "Alt/Az" position.
Ideally if the ASCOM driver can pass through the park command to APCC , it would do the job (since APCC is set to park to Home position). However, since I dont see that option, I set up User defined Alt-Az position as the park position.
The issue I see is, the resolution of the Alt/Az of APCC is higher than that of ASCOM driver,
The APCC Alt-Az is set to 30:54:34.8 and 00:00:00.6
The ASCOM sees it as 30:54:34 and 00:00:01
If I do park from the ASCOM driver to the Alt/Az it does not go the require position (it is slightly off but enough to be a problem). If I park from APCC, it is perfect.
Is there any setting or option I am missing (I did look into the documentation ) but cant figure out how to get the park to go to the Home position .
Thanks in advance