Re: APCC shows Altitude at 0 in Park 3


Bill Long
 

Right. If Wayne issued a malformed RCAL at some point, homing the mount will clear that. As a rule of thumb with both of my encoder mounts, I use the APPM "RECAL At Zenith" option during the model build. After that finishes I do home the mount (probably not needed) and I get on my target and use APCC to do a APPM Solve and Sync. 


From: main@ap-gto.groups.io <main@ap-gto.groups.io> on behalf of Ray Gralak <iogroups@...>
Sent: Friday, March 12, 2021 11:31 PM
To: main@ap-gto.groups.io <main@ap-gto.groups.io>
Subject: Re: [ap-gto] APCC shows Altitude at 0 in Park 3
 
If the mount's site latitude and longitude are correct, just home the mount, as Bill suggested.

If the mount's latitude is wrong, power cycle the mount and make sure APCC is initializing the mount with the proper site lat/long.

-Ray

> -----Original Message-----
> From: main@ap-gto.groups.io [mailto:main@ap-gto.groups.io] On Behalf Of Wayne Hixson via groups.io
> Sent: Friday, March 12, 2021 10:02 PM
> To: main@ap-gto.groups.io
> Subject: Re: [ap-gto] APCC shows Altitude at 0 in Park 3
>
> Hi Ray, I have tried that no luck. Trying reboot and restart the CP5 right now...
>
> nope. This did happen some time ago and you had a solution if I recall but can’t remember!
>






Join main@ap-gto.groups.io to automatically receive all group messages.