Re: Mach2 tracking below custom horizon


Luca Marinelli
 
Edited

So I went through the SGP log and the application was sitting idly not sending any commands to AP ASCOM driver after the end of the APPM run. As I said, I was not running a sequence, only using SGP for camera control and plate solving.

Ray, I copied the APPC and AP ASCOM logs in my Dropbox if you want to take a look, but I am quite certain this had nothing to do with an errant request from a client.

APPC/AP ASCOM logs: https://www.dropbox.com/s/bh3l6k5sut40hfi/ApccZip-Luca_Marinelli-2021-01-22-061412.zip?dl=0
SGP log: https://www.dropbox.com/s/o3gdtid7curwcys/sg_logfile_20210120175716.log?dl=0

The APPM run ended at 7:47pm 1/20/2021 near the Western horizon.

Thanks,

Luca

Join main@ap-gto.groups.io to automatically receive all group messages.