Re: Mach-2 can not reach target

Konstantin von Poschinger

Sorry, I have done now the right on! I will report when all is fine now!
By the way I am imaging with a Stowaway on the Mach2. It is a nice combination and I am happy with the performance. I have ASI6200 with a 7 position filter wheel attached behind the flattener.


Am 17.08.2020 um 22:15 schrieb uncarollo2 <chris1011@...> via <>:

As Roland said I can prevent this with the $SLD0# command.
Well, Roland said it wrong and Howard said it right. Use :LR0# to turn off the RA limits at the Meridian.


-----Original Message-----
From: Konstantin von Poschinger <KPoschinger@...>
Sent: Mon, Aug 17, 2020 3:10 pm
Subject: Re: [ap-gto] Mach-2 can not reach target

Hello Howard,

I have set the limits on both sides! The problem is to move from a cw up position on the east direct to a cw up position in the west. As Roland said I can prevent this with the $SLD0# command. I will test that. 


Konstantin v. Poschinger

Hammerichstr. 5
22605 Hamburg

Am 17.08.2020 um 21:42 schrieb Howard Hedlund <howard@...>:

Setting an appropriate meridian delay BEFORE the counterweight shaft goes up will also avoid the problem.  This is easily set in APCC.

Join to automatically receive all group messages.