Re: Mach-2 can not reach target

Konstantin von Poschinger

Hello Howard,

I have set the limits on both sides! The problem is to move from a cw up position on the east direct to a cw up position in the west. As Roland said I can prevent this with the $SLD0# command. I will test that. 


Konstantin v. Poschinger

Hammerichstr. 5
22605 Hamburg

Am 17.08.2020 um 21:42 schrieb Howard Hedlund <howard@...>:

Setting an appropriate meridian delay BEFORE the counterweight shaft goes up will also avoid the problem.  This is easily set in APCC.

Join to automatically receive all group messages.