From: Jodi McCullough <jmccul@...>
To: firstname.lastname@example.org <email@example.com>
Sent: Wed, Jun 3, 2020 11:34 am
Subject: Re: [ap-gto] Mount is "lost"
George at AP is a big help. I suspect the battery in the hand paddle is bad. We had to replace the wired in one then it was fine. Gave us similar problems.
I am the 2nd owner of an AP900 that is permanently mounted in my observatory. When I got it I did a preliminary PA, 2-star calibration, and then a Quick Drift Meridian Delay. First session imaging seemed
to go well. I use the hand controller which I initialized as per instructions. The only external program connected to the mount is PHD2. After a too long hiatus, the next session was a disaster. The mount wouldn't point in the correct spot- all the GoTos were
way off. Last weekend I tried to recalibrate startingfrom the Park 3 position using the 2- star method. I could get the scope to get close to the 2nd star, but when slewing back to the 1st star it was off. I went back and forth. (In this case between Arcturus
and Spica.) I faithfully followed the instructions in the manual but too no avail. Then theclouds came. I must be doing something very wrong. I would appreciate any and all help. (One of my hurdles is that I am 160 miles from my observatory during the week
but here in Brooklyn, the internet is great. At the western MA site, the internet stinks so it is difficult to communicate on site.) Thanks again.<20200529_165904.jpg>