Re: CP3 Power Connector
|
Bill Long
I drink too much coffee to trust myself doing that. :) Ha!
From: main@ap-gto.groups.io <main@ap-gto.groups.io> on behalf of uncarollo2 <chris1011@...> via groups.io <chris1011@...>
Sent: Tuesday, June 2, 2020 3:06 PM To: main@ap-gto.groups.io <main@ap-gto.groups.io> Subject: Re: [ap-gto] CP3 Power Connector You can solder it back on.
Rolando
-----Original Message-----
From: Bill Long <bill@...> To: main@ap-gto.groups.io <main@ap-gto.groups.io> Sent: Tue, Jun 2, 2020 4:59 pm Subject: Re: [ap-gto] CP3 Power Connector
The negative lead on the motor popped off. Its coming back to you guys for repair. Ships out today via UPS air. I knew I should have just removed the axis to do that part, I am betting some extra gravity was at play and put more tension on the wiring harness
than I had anticipated. Lesson learned. 🙂
In the meantime, I get to play with the Mach 1 so I am not too sad.
From: main@ap-gto.groups.io <main@ap-gto.groups.io> on behalf of uncarollo2 <chris1011@...> via groups.io <chris1011@...>
Sent: Tuesday, June 2, 2020 2:57 PM To: main@ap-gto.groups.io <main@ap-gto.groups.io> Subject: Re: [ap-gto] CP3 Power Connector I hope your 1100 is ok ;^((
Rolando
-----Original Message-----
From: Bill Long <bill@...> To: main@ap-gto.groups.io <main@ap-gto.groups.io> Sent: Tue, Jun 2, 2020 4:56 pm Subject: Re: [ap-gto] CP3 Power Connector
Thanks Roland.
After my snafu with the DEC motor on the 1100 (my fault) the (new to me but used) Mach 1 went into service last night. Works like a dream as expected. :)
From: main@ap-gto.groups.io <main@ap-gto.groups.io> on behalf of uncarollo2 <chris1011@...> via groups.io <chris1011@...>
Sent: Tuesday, June 2, 2020 2:53 PM To: main@ap-gto.groups.io <main@ap-gto.groups.io> Subject: Re: [ap-gto] CP3 Power Connector Yes, center is pos.
Rolando
-----Original Message-----
From: Bill Long <bill@...> To: main@ap-gto.groups.io <main@ap-gto.groups.io> Sent: Tue, Jun 2, 2020 4:47 pm Subject: [ap-gto] CP3 Power Connector
Simple question here -- on the CP3 box I assume the 12V power accepts a 2.1x5.5 center positive 12 volt cable - correct? I would like to just use a Powerpole cable I have here vs the cig plug one.
|
|
|