Re: Mach2 Unguided testing continues


Bruce Donzanti
 

ok- I don't doubt that; your efforts and ingenuity is greatly appreciated; no reason to get snippy; a simple no would have sufficed to someone who bought two of your mounts or the suggestion that Robert presented to me about an extension to the keypad

On Wed, May 27, 2020 at 9:01 PM uncarollo2 <chris1011@...> via groups.io <chris1011=aol.com@groups.io> wrote:
It's a keypad routine. We spent a great deal of time developing this program for the keypad. I can't even count the number of hours that the three of us put into development (Charles - keypad software, Mike - CP4/5 software, and me the conductor of it all).

Rolando



-----Original Message-----
From: Bruce Donzanti <donza2735@...>
To: main@ap-gto.groups.io
Sent: Wed, May 27, 2020 7:42 pm
Subject: Re: [ap-gto] Mach2 Unguided testing continues

Roland 

My CP4 is about 8 ft above my laptop desk in my observatory.   So, not sure the hand controller will reach that far down and I do not want to purchase APCC.  Does that mean I am out of luck or is there an app just to mimic the hand controller routine from the CP4 to the laptop?

Bruce

On Wed, May 27, 2020 at 8:29 PM uncarollo2 <chris1011@...> via groups.io <chris1011=aol.com@groups.io> wrote:
Yes, this is a hand controller routine.

Rolando



-----Original Message-----
From: Worsel via groups.io <bryancashion=yahoo.com@groups.io>
To: main@ap-gto.groups.io
Sent: Wed, May 27, 2020 7:04 pm
Subject: Re: [ap-gto] Mach2 Unguided testing continues

Roland

Encoders are NOT required then...just a CP4 with updated firmware.  I recognize this is not yet available.

I also recall an earlier thread indicating the APCC Pro would be able to do the same, if a hand controller is not used.

Bryan

Join main@ap-gto.groups.io to automatically receive all group messages.