Re: Mach2 Unguided testing continues


Bruce Donzanti
 

Roland 

My CP4 is about 8 ft above my laptop desk in my observatory.   So, not sure the hand controller will reach that far down and I do not want to purchase APCC.  Does that mean I am out of luck or is there an app just to mimic the hand controller routine from the CP4 to the laptop?

Bruce

On Wed, May 27, 2020 at 8:29 PM uncarollo2 <chris1011@...> via groups.io <chris1011=aol.com@groups.io> wrote:
Yes, this is a hand controller routine.

Rolando



-----Original Message-----
From: Worsel via groups.io <bryancashion=yahoo.com@groups.io>
To: main@ap-gto.groups.io
Sent: Wed, May 27, 2020 7:04 pm
Subject: Re: [ap-gto] Mach2 Unguided testing continues

Roland

Encoders are NOT required then...just a CP4 with updated firmware.  I recognize this is not yet available.

I also recall an earlier thread indicating the APCC Pro would be able to do the same, if a hand controller is not used.

Bryan

Join main@ap-gto.groups.io to automatically receive all group messages.