Re: Advice needed: I can rock RA in Mach1GTO (very small), should I adjust?
toggle quoted messageShow quoted text
I did what Rolando posted in the instructions below. I could actually turn the nut by 1/4 turn! I didn't have a spanner wrench and so I made a fixture to fit into the two holes. I first tightened using just my fingers and then used a pair of pliers to do the final tightening. I don't think I had a lot of leverage and so I don't think I overtightened the nut. However, if I did, can overtightening cause problems?
Even after tightening the nut, there was still a small RA play, I think < 10 mils that I both feel and see. George then asked me to adjust the backstop. And voila, the RA play disappeared.
It's fixed now (unless I managed to screw up something else) but I am really surprised that I could turn the nut by 1/4 turn.
Thanks to everybody who posted here, Rolando and George.
On Sunday, May 17, 2020, 03:28:09 PM CDT, uncarollo2 <chris1011@...> via groups.io <chris1011@...> wrote:
Thank you for posting that.
From: Gabe Shaughnessy <gshaughnessy@...>
Sent: Sun, May 17, 2020 3:22 pm
Subject: Re: [ap-gto] Advice needed: I can rock RA in Mach1GTO (very small), should I adjust?
I had a similar issue to this with my AP1100. I adjusted the backstop, but that didn't help. I followed some additional adjustment instructions given by Roland here. Worked like a charm!