Re: Advice needed: I can rock RA in Mach1GTO (very small), should I adjust?


Bill Long
 

Then it's the backstop. It's largely irrelevant though. I would leave it alone.


From: main@ap-gto.groups.io <main@ap-gto.groups.io> on behalf of Cheng-Yang Tan via groups.io <cytan299@...>
Sent: Sunday, May 17, 2020 12:49 PM
To: Frank Widmann via groups. io <fjwidmann@...>; main@ap-gto.groups.io <main@ap-gto.groups.io>
Subject: Re: [ap-gto] Advice needed: I can rock RA in Mach1GTO (very small), should I adjust?
 
My Mach1GTO is from the final batch made. So it should be this one:


I'm waiting for the official word before going ahead with it.

cytan

On Sunday, May 17, 2020, 02:45:48 PM CDT, Bill Long <bill@...> wrote:


It's important to know which Mach 1 it is.


From: main@ap-gto.groups.io <main@ap-gto.groups.io> on behalf of Frank Widmann via groups.io <fjwidmann@...>
Sent: Sunday, May 17, 2020 12:42 PM
To: main@ap-gto.groups.io <main@ap-gto.groups.io>
Subject: Re: [ap-gto] Advice needed: I can rock RA in Mach1GTO (very small), should I adjust?
 
AP has a procedure for adjusting the mesh between the worm and the worm gear that will eliminate the play in either axis. The play is easier to detect in RA because of the large moment arm provided by the counterweight shaft. Declination should be checked to if it has been a while. The procedure is available on line under Support.

Frank

On May 17, 2020, at 8:47 AM, Peter Bresler via groups.io <PABresler@...> wrote:

I also noted some play in the RA in my Mach1. I tried the lever adjustment but it made no change. The entire gear box moves a little.

Join main@ap-gto.groups.io to automatically receive all group messages.