Re: Mach1 (spring loaded vers) has gear slop?
toggle quoted messageShow quoted text
I use a finger on each side of the gearbox to slightly press down from side to side so it rocks back and forth. Once it's in the middle I release some pressure tighten the two screws. If it's too loose you will have that small wiggle. If it's too tight it's hard to tell if you haven't done it before. Don't press hard but you can use two fingers.
Sent from mobile device.
-------- Original message --------
From: Ron Kramer <ronkramer1957@...>
Date: 4/24/20 8:35 PM (GMT-06:00)
Subject: Re: [ap-gto] Mach1 (spring loaded vers) has gear slop?
The wiggle in RA when I wiggle the counter weight shaft. There is a instruction page that shows you losen the 2 screws and apply thumb pressure then tighten the two screws.
I did this a year or two ago and and it worked GREAT. Now when I try it seems there is no room for me to push on with my thumb. SO doing this does not remove the slop/wiggle in RA.
Manual titled Auto Adjusting gearbox no more work meshing.
This thumb action in photo no longer takes out wiggle.
On Mon, Apr 20, 2020 at 1:11 PM uncarollo2 <chris1011@...> via groups.io <firstname.lastname@example.org> wrote: