I was able to connect to the scope in APPM after checking off
Auto Config and Update Now in APCC.
I presume that's all that was needed?

Yes.

Hint: There is very good information in the help file. Clicking the "?" button in many of the control group boxes in APCC will bring you to the relevant section of the help file.

-Ray Gralak
Author of APCC (Astro-Physics Command Center): http://www.astro-physics.com/index.htm?products/accessories/software/apcc/apcc
Author of PEMPro V3: https://www.ccdware.com
Author of Astro-Physics V2 ASCOM Driver: https://www.siriusimaging.com/apdriver

-----Original Message-----
From: main@ap-gto.groups.io [mailto:main@ap-gto.groups.io] On Behalf Of Isphotoman via Groups.Io
Sent: Wednesday, November 6, 2019 8:41 PM
To: main@ap-gto.groups.io
Subject: [ap-gto] APPM - can't connect to Driver #APCC

[Edited Message Follows]

I keep getting an error when I try to connect to the scope in APPM. I can connect to my mount through MaximDL. I
can connect to the camera fine. When I click on Driver to set it up I get this error: "Error Opening ASCOM setup
dialog. Please check that the Astro Physics V2 Telescope driver is installed. Com Object that has been separated
from its underlying RCW cannot be used.

I was able to connect to the scope in APPM after checking off Auto Config and Update Now in APCC. I presume
that's all that was needed?
Thank you
Claude