Re: Meridian Delay + Plate Solve with SGPro?


cford81@...
 

Hi Ray - thought of that but I have them disabled at the moment.

Chris Ford



From: "'Ray Gralak (Groups)' groups3@... [ap-gto]"
To: ap-gto@...
Sent: Saturday, December 16, 2017 7:55:09 PM
Subject: RE: [ap-gto] Meridian Delay + Plate Solve with SGPro?

 

Hi Chris,

Do you have Meridian limits enabled? If you do then the manual meridian limit you set will be changed to the Meridian limit value on the first slew.

-Ray Gralak
Author of APCC (Astro-Physics Command Center): http://www.astro-physics.com/index.htm?products/accessories/software/apcc/apcc
Author of PEMPro: http://www.ccdware.com
Author of Astro-Physics V2 ASCOM Driver: http://www.gralak.com/apdriver
Author of PulseGuide: http://www.pulseguide.com
Author of Sigma: http://www.gralak.com/sigma

> -----Original Message-----
> From: ap-gto@... [mailto:ap-gto@...]
> Sent: Saturday, December 16, 2017 7:07 PM
> To: ap-gto@...
> Subject: [ap-gto] Meridian Delay + Plate Solve with SGPro?
>
>
>
> Has anyone managed to plate solve using SGPro with the telescope in counterweight up position using the
> Meridian Delay feature in APCC?
>
> When I set the Meridian Delay in APCC to 1-hour, the scope/mount slews to the correct pointing position with
> counter weights up. When I then do an SGPro plate solve for fine pointing precision, the plate solves
> successfully but the scope/mount then flips back to its normal (undelayed) position with counter weights down. I
> was wondering perhaps if it is the original data in the header of the plate solve image or perhaps SGPro is not
> receiving the delay from APCC. Any pointers (sorry) on how to do this?
>
> Chris
>
>
>
>
>


Join main@ap-gto.groups.io to automatically receive all group messages.